Kyocera FS-4200DN FS-2100DN/4100DN/4200DN/4300DN Operation Guide - Page 133
IPSec IPSec setting, LAN Interface LAN Interface setting, AppleTalk, IPSec, LAN Interface, 10Base-Half
View all Kyocera FS-4200DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
Operation Panel AppleTalk: a b 1 Off *2**O*n 2 Press [OK]. The AppleTalk screen appears. 3 Press or to select whether AppleTalk is enabled. 4 Press [OK]. The AppleTalk setting is set and the Basic menu reappears. IPSec (IPSec setting) IPSec (IP Security Protocol) is a security protocol adopted as the standard by the IETF for authentication and encryption in the third network layer (IP layer). It can be used with both IPv4 and IPv6. Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP addresses. IPSec: a b *1**O*f**f 2 On 1 In the Basic menu, press or to select IPSec. 2 Press [OK]. The IPSec screen appears. 3 Press or to select whether IPSec is enabled. 4 Press [OK]. The IPSec setting is set and the Basic menu reappears. LAN Interface (LAN Interface setting) Specify the settings for the LAN interface to be used. The default setting is Auto. Note LAN Interface is only displayed when the optional network interface kit (IB-50) is installed. LAN Interface: a b *1**A*u**t*o 2 10Base-Half 3 10Base-Full 1 In the Basic menu, press or to select LAN Interface. 2 Press [OK]. The LAN Interface screen appears. The available LAN Interface are as follows: Auto 10Base-Half 10Base-Full 100Base-Half 100Base-Full 1000Base-T 3 Press or to select the desired LAN Interface. 4 Press [OK]. The LAN Interface is set and the Basic menu reappears. 4-71