Toshiba ESTUDIO355 Troubleshooting Guide - Page 71
Make sure that the following two requirements are met before test stapling, Close the front cover
View all Toshiba ESTUDIO355 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
1.TROUBLESHOOTING FOR THE HARDWARE 1 TROUBLESHOOTING FOR THE HARDWARE 8 Make sure that the following two requirements are met before test stapling: y The finisher is securely attached on the equipment. y A3, B4, A4-R, LD, or LT-R paper is loaded in the drawer When the message "Check staple cartridge in the Saddle Stitch unit" is displayed, this step is unnecessary. Proceed to step 9. 9 Close the front cover of the finisher. When the message "READY (CHECK STAPLER)" is displayed, test stapling starts automatically. Test stapling is necessary to prevent void stapling. Note that the test stapling starts automatically when the two requirements in step 8 are met with the front cover of the finisher closed. If the test stapling does not start, make sure to check the two requirements again. Then open and again close the front cover of the finisher. Refilling With Staples 69