Toshiba M200-ST2002 Maintenance Manual - Page 105

3.2 Executing the Diagnostic Test 3 Tests and Diagnostics Select the option you want to execute on the test menu and press Enter. When you select 1SYSTEM TEST, the following message will appear: SYSTEM TEST XXXXXXX XXXX DIAGNOSTIC TEST VXXX [Ctrl]+[Break] : test end [Ctrl]+[C] : key stop SUB-TEST : XX PASS COUNT: XXXXX WRITE DATA: XX ADDRESS : XXXXXX ERROR COUNT: XXXXX READ DATA : XX STATUS : XXX SUB-TEST MENU : 01 - ROM checksum 02 - Dock/Undock 03 04 - Fan ON/OFF 05 - Geyserville 06 - Quick charge 07 - DMI read 08 - DMI write 09 10 - Calibration 11 - 12 - Second FAN ON/OFF 99 - Exit to DIAGNOSTIC TEST MENU NOTE: The menu displayed on your computer may be slightly different from the one shown above. Select the subtest number to execute from the subtest menu and press Enter. The following message will appear: TEST LOOP : YES (or NO) ERROR STOP : YES (or NO) Use the right and left arrow keys to move the cursor to the desired option. Selecting YES in TEST LOOP increases the pass counter by one each time the test cycle ends, and restarts the test cycle. Selecting NO in TEST LOOP terminates the test and returns to the subtest menu after one test cycle is complete. Portege M200 Maintenance Manual (960-457) 3-5