Toshiba M200-ST2002 Maintenance Manual - Page 190
Overview, before a particular FRU can be removed. The numbers in the chart indicate the relevant
![]() |
View all Toshiba M200-ST2002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 190 highlights
4.1 Overview 4 Replacement Procedures 4 Replacement Procedures 4.1 Overview This chapter describes the procedure for removing and replacing the field replaceable units (FRUs) in the PC. It may not be necessary to remove all the FRUs in order to replace one. The chart below provides a guide as to which other FRUs must be removed before a particular FRU can be removed. The numbers in the chart indicate the relevant section numbers in this manual. In all cases when removing an FRU, the battery pack must also be removed. When repairing an FRU that is the potential cause of a computer fault, use the chart to determine the order in which FRUs need to be removed. 4.3 PC card SD memory card 4.2 Battery pack 4.6 Memory module 4.7 HDD 4.4 Keyboard 4.8 Base cover assembly 4.9 4.10 Mini MDC 4.6 4.12 FAN/ RTC 4.13 Blue 4.14 Hinge PCI modem CPU battery tooth cable module 4.15 System board 4.16 Speaker/LED board 4.18 Pen holder/ Battery lock/ Base latch assembly 4.17 Second FAN 4.5 Touch pad 4.19 LCD/FL inverter 4.21 Digitizer 4.24 Florescent lamp 4.8 Application Switch/ Power switch/ LCD latch assembly 4.22 LCD harness/ Hinge assembly 4.23 Hinge Switch board (Example) nChart Notation The chart shows the case for the following example: uRemoving the system board All FRUs down to the "4.9 Mini PCI" to "4.14 Hinge cable" units immediately above the system board must be removed. Similarly, as this requires the removal of all the units from "4.3 PC card" to "4.8Base cover assembly" must be also removed. 4.3 PC card/ SD memory card 4.2 Battery pack 4.6 Memory module 4.7 HDD 4.4 Keyboard 4.8 Base cover assembly 4.9 4.10 Mini MDC 4.6 FAN/ PCI modem CPU 4.12 RTC battery 4.13 Blue tooth module 4.14 Hinge cable 4.15 System board 4.16 Speaker/LED board 4.18 Pen holder/ Battery lock / Base latch assembly 4.17 Second FAN 4.5 Touch pad 4.19 LCD/FL inverter 4.21 Digitizer 4.24 Florescent lamp 4.8 Application Switch/ Power switch / LCD latch assembly 4.22 LCD harness/ Hinge assembly 4.23 Hinge Switch board Portege M200 Maintenance Manual (960-457) 4 -1
![](/manual_guide/products/toshiba-m200st2001-maintenance-manual-c5b52ff/190.png)