Toshiba M200-ST2002 Maintenance Manual - Page 246

4.22 LCD harness / Hinge assembly 4 Replacement Procedures Installing the LCD harness and the hinge assembly The following describes the procedure for installing the LCD harness and the hinge assembly. (See Figure 4-39 to 4-40.) 1.Pass the LCD harness and microphone cable through the hole of the hinge. 2.Install the hinge assembly and secure it with the following screws. • M2.5×6B FLAT BIND screw x4 (Described as 6B in the figure) 3.Arrange the cables along the guide to the both sides and secure them with the LCD earth plate. 4.Install the LCD harness hold plate for holding the LCD harness and secure it with the following screw. • M2×2.8B FLAT BIND screw x1 (Described as 2.8 in the figure) 5.Turn the hinge plate counterclock wise by 90 degrees. Install the hinge rear cover and secure it with the following screws. • M2.5×6B FLAT BIND screw x2 (Described as 6B in the figure) • M2.5×6C FLAT BIND screw x2 (Described as 6C in the figure) 6.Hold the LCD cover facing you and attach the following antennas with double- faced tapes in the order of the main wireless LAN antenna (with white cable), Bluetooth antenna (with brown cable) and sub wireless LAN antenna (with black cable). NOTE: When installing the Wireless LAN antennas and Bluetooth antenna, make sure to install them along the mark line of the computer. And also, make sure of the position of each antenna cable installed on the antenna. 7.Install the microphones to the guide pin. 8.Arrange the cables form each antenna and stick six acetate tapes for securing the cables. Caution: Place each cable from the hinge assembly in the order of wireless LAN cable, microphone cable and LCD harness. Portege M200 Maintenance Manual (960-457) 4-57