Toshiba M200-ST2002 Maintenance Manual - Page 232

4.19 LCD unit/FL inverter 4.19 LCD unit/FL inverter 4 Replacement Procedures Removing the LCD unit and FL inverter The following describes the procedure for removing the LCD unit and FL inverter. (See Figure 4-31 to 4-34.) NOTE: When removing the LCD unit or FL inverter, do not press the LCD part of the base cover assembly. It may cause the breakage of the hinge assembly. Use a stand or something to make the LCD part flat for installing the LCD unit and FL inverter, and to make the base assembly floating from the ground. 1.Remove the four mask cushions from the LCD cover by using a needle. Remove the two mask seals from the display mask. 2.Remove the following screws securing the LCD cover. • M2.5×6B FLAT BIND screw x6 (Described as 6 in the figure) 3.Open the display until LCD and the base assembly become horizontal. Insert your nails into slit of the LCD and release the latches from the bottom side of the LCD. Slit for releasing the latches 6 6 6 6 6 Mask seal 6 Mask cushion Figure 4-31 Removing the LCD mask Portege M200 Maintenance Manual (960-457) 4-43