Toshiba M200-ST2002 Maintenance Manual - Page 234

4.19 LCD unit/FL inverter 4 Replacement Procedures NOTE: When putting the LCD unit on the display cover, lay a mat or something on under the LCD unit to protect the computer and the LCD from a scratch or breakage. M2x4Z BIND Glass tape Glass tape Figure 4-34 Removing the LCD Installing the LCD unit and FL inverter The following describes the procedure for installing the LCD unit and FL inverter. (See Figure 4-31 to 4-34.) 1.With the LCD unit standing on the display cover, connect two LCD cables on the back of LCD and secure them with two glass tapes. 2.Lay down the LCD on the LCD cover and secure it with the following screws. • M2×4Z BIND screw x4 3.Connect the two harnesses to the connector of the FL inverter. Secure the FL inverter with the following screw. Secure the FL inverter with the following screw. • M2×4Z BIND screw x1 4.Install the cross function button 5.Install the LCD mask. Press the LCD mask until latches fasten securely. NOTE: When installing the LCD mask, wipe the LCD mask with a soft cloth and make the back of the LCD mask clean with an ionizer. And also, make sure that the cross function button is installed. Portege M200 Maintenance Manual (960-457) 4-45