Toshiba M200-ST2002 Maintenance Manual - Page 209

4 Replacement Procedures 4.8 Base cover assembly 5. Remove the following screws from the bottom of the computer. • M2.5×6B • M2.5×3B 6 6 FLAT BIND screw S-THIN screw 6 66 6 6 6 6 6 6 6 6 x19 (Described as 6 in the figure) x1 (Described as 3 in the figure) 6 6 6 6 6 3 6 Figure 4-11 Removing screws 6. Pull up the base cover assembly to remove. Installing the base cover assembly The following describes the procedure for installing the base assembly. (See Figure 4-9 to 4-11.) 1. Install the base cover assembly o n the base assembly and hook the latches. 2. Secure the base cover assembly with the following screws. • M2.5×6B FLAT BIND screw x19 • M2.5×3B S-THIN screw x1 3. Connect the second FAN cable to the connector on the system board near the memory slot and push the cable into the slot of the computer. 4. Turn over the computer. 5. Turn up the insulator and connect the LED flexible cable and Touch Pad flexible cable to the connector PJ3260 and PJ3240. 6. Turn up the insulator and connect the speaker cable to the connector PJ6005. Stick the glass tape to secure the insulator on the speaker cable. 4 -2 0 Portege M200 Maintenance Manual(960 -457)