Toshiba M200-ST2002 Maintenance Manual - Page 177

3.26 SETUP 3 Tests and Diagnostics (*1) The FDD is looked for when the boot disk is contained in the external FDD. When an SD memory card is set as the boot disk, the external FDD is looked for first. Next, the SD memory card is looked for. (*2) The HDDs are looked for in the order specified in "HDD Priority". (*3) The CD-ROM is available only with the optional optical disk drive. (b) HDD Priority Use this option to set the priority for booting the computer from the HDD. Built-in HDD -> PC Card The computer will look for the built-in HDD first, next the PC card. (Default) PC Card -> Built-in HDD The computer will look for the PC card first, next the built-in HDD. (c) Network Boot Protocol Use this option to set the starting method via a network. PXE Sets to PXE protocol. (Default) RPL Sets to RPL protocol. 7. Display This group of options configures the computer's display. (a) Power On Display This option is used to select the display when booting up. Auto-Selected Selects an external monitor if one is connected. Otherwise it selects the internal LCD. (Default) LCD+Analog RGB Selects both the internal LCD and the external CRT for simultaneous display. System LCD only Selects the internal monitor even if the external LCD is connected. NOTE: When LCD+Analog RGB is selected while connecting the external display not corresponding to SVGA mode, no image appears on the display. (b) LCD Display Stretch LCD Display Stretch enables or disables a larger display area of the screen. Portege M200 Maintenance Manual (960-457) 3-75