Toshiba M200-ST2002 Maintenance Manual - Page 250
Replacing the 12.1 Inch Toshiba Fluorescent Lamp, Disassembling the module, Fluorescent, Caution
View all Toshiba M200-ST2002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 250 highlights
4.24 Fluorescent Lamp 4 Replacement Procedures 4.24.1 Replacing the 12.1 Inch Toshiba Fluorescent Lamp The following describes the procedure for replacing the fluorescent lamp. (See Figure 442 to 4-53.) Disassembling the module 1.Peel off tapes and insulating sheets. 1) Place carefully the module face up on a clean and flat worktable. To avoid scratching the face of the LCD module, make sure the table is free of dirt and dust. Place a protection sheet (soft cloth or similar one) over the front of the module. 2) Peel off the double-faced tape of the insulation sheet side. (Do not peel off the tape on the bezel side.) Caution: 1) Be careful not to damage the TAB, PCB, B/L and reflection sheet. 2) Leave the insulation sheet on the bezel to reuse it later. 3)Be careful not to damage the TAB and PCB when peeling off double-faced tape on the insulation sheet. Side tape of insulation sheet Double-faced tape of insulation sheet Bezel tape Bezel tape Figure 4-42 Replacing Toshiba f luorescent lamp(1) Portege M200 Maintenance Manual (960-457) 4-61