Toshiba M200-ST2002 Maintenance Manual - Page 249

4 Replacement Procedures 4.24 Fluorescent Lamp 4.24 Fluorescent Lamp This system uses LCD modules from the following suppliers. The procedure for replacing the fluorescent lamp is different for each LCD module. Refer to the appropriate procedure. Type 12.1 inch Part.No Supplier G33C00019110 Toshiba Section 4.24.1 Note:- When working with an LCD module, always use a flat, grounded table. - Handle the backlight unit in the environment without dust, such as on the clean bench. Keep the worktable free from any screws or other material that may scratch the LCD surface. - Use an anti-static or protective sheet. - When replacing the FL unit, cover with a finger protector or similar to prevent dirtying or scratching the LCD panel. - Take care when handling the lamp. Excessive force may break the lamp. - Take care not to dirt y or deform the lamp reflector. - Ensure always that the power of the LCD module is turned off before connecting or disconnecting cables and connectors. 4 -6 0 Portege M200 Maintenance Manual(960 -457)