Toshiba M200-ST2002 Maintenance Manual - Page 216

4.11 FAN/CPU 4 Replacement Procedures 4. If there is already silicon grease on the CPU and FIN, clean it with a cloth. Using a special applicator, apply silicon grease so that the CPU c hip on the CPU is completely covered. Note: Apply the silicon grease enough to cover the chip surface using the special applicator. The amount is 0.25ml. Figure 4-19 Applying Silicon Crease 5. Install the FIN on the CPU. Install the CPU hold plate on them and secure it with the following screws in the order of the marks (1 to 4) on the CPU hold plate. • M2×4Z BIND screw x4 6. Connect the rotation sensor cable to the connector PJ3280 on the system board. 7. Set the FAN cable along the side of the FAN and secure it with the glass tape. 8. Connect the FAN cable to the connector PJ8400 on the system board. Caution: Make sure the FAN cable does not pass on the memory connectors. FAN cable Glass tape PJ8400 Figure 4-20 Installing the FAN cable Portege M200 Maintenance Manual (960-457) 4-27