Toshiba M200-ST2002 Maintenance Manual - Page 245

4 Replacement Procedures 4.22 LCD harness / Hinge assembly 4.22 LCD harness / Hinge assembly Removing the LCD harness and hinge assembly The following describes the procedure for removing the LCD harness and hinge assembly. (See Figure 4-39.) 1. Remove the following screws securing the hinge assembly. • M2.5×6B FLAT BIND screw x2 (Described as 6B in the figure) • M2.5×6C FLAT BIND screw x2 (Described as 6C in the figure) 2. Remove the hinge rear cover and hinge assembly from the base assembly by turning the hinge counterclockwise by 90 degrees. 3. Remove the following screw securing the LCD harness hold plate. • M2×2.8B FLAT BIND screw x1 (Described as 2.8 in the figure) 4. Remove the following screws securing the hinge on the both sides. • M2.5×6B FLAT BIND sc rew x4 (Described as 6B in the figure) LCD earth plate 6B 6B 6C 6B LCD harness hold plate 6B 2.8 6B 6B 6C Figure 4-39 Removing the hinge 5. Remove the LCD earth plates securing the both sides of the cables. 6. Peel off the six acetate tapes securing the wireless LAN antenna cables, Bluetooth cable and microphone cable. 7. Remove the microphone cables. 8. Remove the LCD harness. 4 -5 6 Portege M200 Maintenance Manual(960 -457)