Toshiba M200-ST2002 Maintenance Manual - Page 252

4.24 Fluorescent Lamp 4 Replacement Procedures 3.Removing the bezel 1) Place the module with the insulation sheet facing upwards. 2) Release two latches for the side edge of the bezel and frame. Pulling up the bezel from the bottom side (FL lamp side), release four latches for the top edge of the bezel and remove the bezel from the cell. (The bezel with double-faced tape will be reused.) Caution: 1)When peeling off the double-faced tapes, be careful not to damage the TAB. 2)When removing the bezel, peel off the double-faced tape on the bezel bottom carefully and do not break it and do not deform the bezel. (The bezel with double-faced tape will be reused.) Release the latch for top Remove the bezel while peeling off the double-faced tape Release the latch for side Release the latch for side Pull up the bezel from bottom side Remove the bezel while peeling off the double-faced tape Figure 4-45 Replacing Toshiba f luorescent lamp(4) 4.Spread out the PCB 1) Spread out the PCB horizontally as shown in the drawing below. Portege M200 Maintenance Manual (960-457) 4-63