Toshiba M200-ST2002 Maintenance Manual - Page 75
Procedure 4, Diagnostic Test Program Execution Check, HDD Troubleshooting, Tests and Diagnostics
![]() |
View all Toshiba M200-ST2002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
2.6 2.5" HDD Troubleshooting 2 Troubleshooting Procedure 4 Diagnostic Test Program Execution Check The HDD test program is stored in the Diagnostics Disk. Perform all of the HDD tests in the Hard Disk Drive Test. Refer to Chapter 3, Tests and Diagnostics, for more information about the HDD test program. If an error is detected during the HDD test, an error code and status will be displayed. The error codes and statuses are described in Table 2-5. If an error code is not displayed but the problem still exists, go to Procedure 5. Table 2-5 2.5" HDD error code and status Code 01h 02h 04h 05h 07h 08h 09h 0Ah 0Bh 10h 11h 20h 40h 80h AAh BBh CCh E0h EEh DAh Status Bad command Address mark not found Record not found HDC not reset Drive not initialized HDC overrun error (DRQ) DMA boundary error Bad sector error Bad track error ECC error ECC recover enable HDC error Seek error Time out error Drive not ready Undefined error Write fault Status error Access time out error No HDD Portege M200 Maintenance Manual (960-457) 2-37
![](/manual_guide/products/toshiba-m200st2001-maintenance-manual-c5b52ff/75.png)