Toshiba M200-ST2002 Maintenance Manual - Page 237

4 Replacement Procedures latch assembly 4.20 Application switch board/Power switch board/LCD Installing the Application switchboard/Power switchboard The following describes the procedure for installing the Application switchboard/Power switchboard (See Figure 4-35 to 4-36.) 1. Connect the harness to the connector on the application switchboard. Install the application switchboard along the guide pin on the both side and secure it with the following screws. • M2×4Z BIND screw x1 2. Connect the harness to the connector on the power switchboard. Install the power switchboard along the guide pin on the both side and secure it with the following screws. • M2×4Z BIND screw x1 4.20.2 LCD latch assembly Removing the LCD latch assembly The following describes the procedure for removing the LCD latch assembly (See Figure 4-37.) 1. Remove the following screws securing the LCD latch assembly and remove the LCD latch assembly. • M2.5×4Z FLAT BIND screw x1 M2.5x4Z FLAT BIND LCD latch assembly Figure 4-37 Removing the LCD latch assem bly 4 -4 8 Portege M200 Maintenance Manual(960 -457)