Toshiba M200-ST2002 Maintenance Manual - Page 213
Installing the MDC modem
View all Toshiba M200-ST2002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 213 highlights
4 Replacement Procedures 4.10 MDC modem Installing the MDC modem The following describes the procedure for installing an MDC modem. (See Figure 4-14 to 4-15.) 1. Connect the MDC modem cable to the MDC modem. 2. Connect the MDC modem to the connector PJ3020 on the system board and secure it with the following screws • M2×4Z BIND screw x2 3. After turning up the insulator, arrange the MDC modem cable and connect to the connector PJ3021 on the system board. Stick the glass tape. Caution: When installing the MDC modem cable, make sure the cable does not cover screw holes and is caught by the Fan. PJ3021 Lightly pull the cable not to give the looseness on the MDC modem side. Run the cable through the two holes of the insulator. Make sure that the cable passes over the fin pipe. Run the cable outside of the stud screw of the CPU hold plate. Lightly pull the cable not to give the looseness on the MDC modem side. Run the cable between the MDC modem and mini PCI. Figure 4-15 Installing the MDC Modem 4 -2 4 Portege M200 Maintenance Manual(960 -457)