Toshiba S1 User Manual - Page 123

POWER AND POWER-UP MODES User's Manual Replacing the battery pack When the battery pack reaches the end of its operating life you will need to install a new one. The life of the battery pack is generally about 500 recharges. If the Battery indicator flashes orange shortly after fully recharging the battery, the battery pack needs to be replaced. You might also replace a discharged battery pack with a charged spare when you are operating your computer away from an AC power source. This section explains how to remove and install battery packs. For the detail about removing/installing the Slim Secect Bay 2nd battery pack, refer to Chapter 8, Option Devices. Removing the battery pack To replace a discharged battery pack, follow the steps below. CAUTION: 1. When handling battery packs, be careful not to short circuit the terminals. Also do not drop, hit or otherwise apply impact; do not scratch or break the casing and do not twist or bend the battery pack. 2. Do not remove the battery pack while the computer is in Standby mood. Data is stored in RAM, so if the com puter loses power it will be lose. 3. In Hibernation mode, data will be lose if you remove the battery or disconnect the AC adaptor before the save is completed. Wait for the Fixed HDD/ODD indicator to go out. 1. Save your work. 2. Turn the computer's power off. Make sure the Power indicator is off. 3. Remove all cables connected to the computer. 4. Turn the computer upside down with the back of the computer facing you. 5. Slide the battery release latch to free the battery pack for removal, then lift up the battery pack. 6. Pull the battery pack forward to remove it. CAUTION: For environmental reasons, do not throw away a spent battery pack. Please return spent battery packs to your TOSHIBA dealer. 6-14