Toshiba S1 User Manual - Page 173

Hardware and system checklist A CONNECT display is quickly replaced by NO CARRIER Check the error control setting in your communications application. You can also use the AT\N command. Refer to the chapter on AT commands in online help files for Appendix C, AT Commands. Character display becomes garbled during a communication In data transmission, make sure the parity bit and stop bit settings correspond with those of the remote computer. Check the flow control and communication protocol. You cannot receive an incoming call Check the rings before auto answer setting in your communications application. You can also use the ATS0 command. Refer to the chapter on S-registers in online help files for Appendix D, S-registers. If problems persist, contact your dealer. Standby/Hibernation Problem The system will not enter Standby/Hibernation Procedure Is Windows Media™ Player open? The system might not enter Standby/Hibernation, if Windows Media Player is either playing a selection or finished playing a selection. Close Windows Media Player before you select Standby/ Hibernation. If problems persist, contact your dealer. TROUBLESHOOTING 9-23