Toshiba S1 User Manual - Page 125

POWER AND POWER-UP MODES User's Manual Starting the computer by password If you registered a password as supervisor or user, you must enter it to start the computer. For more information about how to set a password, refer to Chapter 7, HW Setup and Passwords. To start up the computer with the password, follow these steps: 1. Turn on the power as described in Chapter 3, Getting Started and the following message appears: Password = 2. Enter the password. 3. Press Enter. The computer displays the message below while it starts up. Valid password entered, system is now starting up. NOTE: If you enter the password incorrectly three times in a row, the computer shuts off. In this case, you must turn the computer back on to retry password entry. Power-up modes The computer has the following power-up modes: ❑ Boot : Computer shuts down without saving data. Always save your work before you turn the computer off in boot mode. ❑ Hibernation : Data in memory is saved to the hard disk. ❑ Standby : Data is maintained in the computer's main memory. NOTE: Refer also to the sections Turning on the power and Turning off the power in Chapter 3, Getting Started. Windows utilities You can specify the setting in TOSHIBA Power Saver. Hotkeys You can use hotkeys Fn + F3 to enter Standby mode and Fn + F4 to enter Hibernation. See Chapter 5, Keyboard for details. 6-16