ZyXEL MI-7248 User Guide - Page 231

Figure 119 SNMP Trap Group Chapter 38 Access Control The following table describes the labels in this screen. Table 91 SNMP Trap Group LABEL DESCRIPTION Trap Destination IP Select one of your configured trap destination IP addresses. These are the IP addresses of the SNMP managers. You must first configure a trap destination IP address in the SNMP Setting screen. Use the rest of the screen to select which traps the switch sends to that SNMP manager. Type Select the categories of SNMP traps that the switch is to send to the SNMP manager. Options Select the individual SNMP traps that the switch is to send to the SNMP station. See Section 38.2.3 on page 225 for individual trap descriptions. The traps are grouped by category. Selecting a category automatically selects all of the category's traps. Clear the check boxes for individual traps that you do not want the switch to send to the SNMP station. Clearing a category's check box automatically clears all of the category's trap check boxes (the switch only sends traps from selected categories). Apply Click Apply to save your changes to the switch's run-time memory. The switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Cancel Click Cancel to begin configuring this screen afresh. 38.3 Logins Up to five people (one administrator and four non-administrators) may access the switch via the web configurator at any one time. • An administrator is someone who can both view and configure switch changes. The username for the Administrator is always admin. The default administrator password is 1234. " It is highly recommended that you change the default administrator password. MS-7206 User's Guide 231