Cisco 2950 Hardware Installation Guide - Page 54

Installing the Switch Chapter 2 Installation Attaching the Brackets to the Switch The bracket orientation and the screws that you use depend on whether you are attaching the brackets to a 19-, 23-, or 24-inch rack. Follow these guidelines: • When mounting a switch other than a Catalyst 2950G-48-EI, Catalyst 2950SX-48-SI, or Catalyst 2950T-48-SI switch in a 19-inch rack, use two Phillips flat-head screws to attach the long side of the 19- or 24-inch bracket to the switch. See Figure 2-1, Figure 2-2, and Figure 2-3. • When mounting a Catalyst 2950G-48-EI, Catalyst 2950SX-48-SI, or Catalyst 2950T-48-SI switch in a 19-inch rack, use three Phillips flat-head screws to attach the long side of the 19- or 24-inch bracket to the switch. See Figure 2-4, Figure 2-5, and Figure 2-6. • When mounting a Catalyst 2950G-24-EI-DC or Catalyst 2950ST-24 LRE 997 switch in a 23-inch rack, use two Phillips truss-head screws to attach the 23-inch bracket to the switch. See Figure 2-7, Figure 2-8, and Figure 2-9. • When mounting a switch other than a Catalyst 2950G-48-EI, Catalyst 2950SX-48-SI, or Catalyst 2950T-48-SI switch in a 24-inch rack, use two Phillips truss-head screws to attach the 19- or 24-inch bracket to the switch. See Figure 2-10, Figure 2-11, and Figure 2-12. • When mounting a Catalyst 2950G-48-EI, Catalyst 2950SX-48-SI, or Catalyst 2950T-48-SI switch in a 24-inch rack, use three Phillips flat-head screws to attach the 24-inch bracket (part number RCKMNT-1RU=) to the switch. See Figure 2-13, Figure 2-14, and Figure 2-15. Figure 2-1 to Figure 2-15 show how to attach a bracket to one side of the switch. Follow the same steps to attach the second bracket to the opposite side of the switch. Figure 2-1 Attaching Brackets on the Switch in a 19-Inch Rack (Front Panel Forward) 45580 Number-8 Phillips flat-head screws SYST RPS STAT UTIL DUPLX SPEED MODE 1x 2x 3x 4x 5x Catalyst 2950 Switch Hardware Installation Guide 2-8 OL-6156-01