Cisco 521SG Administration Guide - Page 193
Selecting a Display Language, Creating a Dictionary Server Script
UPC - 882658248993
View all Cisco 521SG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 193 highlights
Configuring Regional Parameters and Supplementary Services Localizing Your IP Phone 7 Selecting a Display Language This section describes how to localize the Cisco SPA300 Series and Cisco SPA500 Series IP Phone display language. You can define up to nine languages, in addition to English, to be available and host the dictionaries for each of the languages on the HTTP or TFTP provisioning server. Language support follows Cisco dictionary principles. NOTE The Cisco WIP310 does not support localization. Use the Language Selection parameter to select the phone default display language. The value must match one of the languages supported by the dictionary server. The script (dx value) is as follows: • • Defaults to blank; the maximum number of characters is 512. For example: Spanish During startup, the phone checks the selected language and downloads the dictionary from the TFTP/HTTP provisioning server indicated in the phone configuration. The dictionaries are available at the support website. See Appendix B, "Where to Go From Here," for the website location. The end user can change the language of the phone on the phone by following these steps: STEP 1 Press the Setup button. STEP 2 Select Language, then press the Select soft button. STEP 3 Select Option to change the language. STEP 4 With the desired language highlighted, press Save. Creating a Dictionary Server Script The Dictionary Server Script defines the location of the dictionary server, the languages available and the associated dictionary. The syntax is: Dictionary_Server_Script ua="na"/Dictionary_Server_Script Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 192