Cisco 521SG Administration Guide - Page 29

Getting Started Using IVR on IP Phones Without Screens 1 - 4-Factory Reset-Restores the phone to the factory default software and settings. Enter 1 to confirm or * to cancel. - 5-Debug Server-Recites the address of the debug server. Press 1 to change, or * to go back. The following table lists the IVR options that you can enter immediately after accessing the IVR system. Number 100 110 120 130 140 150 160 170 180 220 221 73738 Option Indicates that Dynamic Host Configuration Protocol (DHCP) is enabled. Recites the IP address of the phone. Recites the netmask of the phone. Recites the gateway address. Recites the MAC (hardware) address of the phone. Recites the phone software version. Recites the primary DNS server address. Recites the HTTP port on which the web server listens. Defaults to 80. Recites the IP multicast address (used by the Cisco SPA 9000 to communicate with the IP phone). Recites the method of call control (SIP or SPCP). Set call control-enter the value for the call control method and press #: • 0: SIP • 1: SPCP To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *. Restores the phone to the factory default software and settings. Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and begin the restore process. Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 28