Cisco 521SG Administration Guide - Page 30

Getting Started Using IVR on IP Phones Without Screens 1 Number 87778 (Cisco SPA501G) 732668 111 121 131 161 181 7932 Option Restore the phone user settings to the default. (Clears all user settings such as speed dials.) Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and begin the restore process. Reboot the phone. Enter # and hang up to begin rebooting. Set a static IP address. Enter the IP address (use * to enter the decimal (.)), then press #. To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *. NOTE DHCP must be disabled to use this option; if DHCP is not disabled, you receive an error message. Set a netmask. Enter the address (use * to enter the decimal (.)), then press #. To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *. NOTE DHCP must be disabled to use this option; if DHCP is not disabled, you receive an error message. Set a gateway. Enter the address (use * to enter the decimal (.)), then press #. To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *. NOTE DHCP must be disabled to use this option; if DHCP is not disabled, you receive an error message. Set the address of the primary Domain Name Server (DNS). Enter the address (use * to enter the decimal (.)), then press #. To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *. Set the IP multicast address (used by the Cisco SPA 9000 to communicate with the IP phone). Enter the address (use * to enter the decimal (.)), then press #. To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *. Enable or disable the web-based configuration utility. Press 1 to enable or 0 to disable, then press #. To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *. Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 29