IBM 8840 Hardware Maintenance Manual - Page 56
information
UPC - 000435863799
View all IBM 8840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Alignment marks Microprocessor 2 Microprocessor 1 Lock tab Microprocessor socket 2 Microprocessor socket 1 e. Carefully close the locking lever to secure the microprocessor in the socket. 8. Install a heat sink on the microprocessor. Attention: v Do not set down the heat sink after you remove the plastic cover. Thermal grease Heat sink v Do not touch the thermal grease on the bottom of the heat sink or set down the heat sink. Touching the thermal grease will contaminate it. For details, see the information about thermal grease on page 42. a. Remove the plastic protective cover from the bottom of the heat sink. b. Make sure that the heat-sink lever is in the open position. c. Align the heat sink above the microprocessor with the thermal grease side down. Press firmly on the heat sink. 46 xSeries 346 Types 8840 and 1880: Hardware Maintenance Manual and Troubleshooting Guide