IBM 8840 Hardware Maintenance Manual - Page 90
FRU/action
UPC - 000435863799
View all IBM 8840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Note: See "System" on page 108 to determine which components a field service technician should replace. Error code/symptom FRU/action 1303 (I2C cable from system board to power cage assembly not found) 1. Cable 2. Power-cage assembly 3. System board 1304 (I2C cable to diagnostic LED board not found) 1. Power switch assembly 2. System board 1600 System board (The system management processor is not functioning) Before replacing a FRU, remove the ac power to the server, wait 20 seconds; then, reconnect the ac power. Wait 30 seconds; then, turn on the server. 1601 1. Remote Supervisor Adapter, if installed (The system is able to communicate to the system management processor, but the 2. System board system management processor failed to respond at the start of POST.) Complete the following steps before replacing a FRU: 1. Remove the ac power to the server, wait 20 seconds; then, reconnect the ac power. Wait 30 seconds; then, turn on the server. 2. Flash update the system management processor. 1602 (Optional service processor not properly installed.) Disconnect all server and option power cords from server, wait 30 seconds, reconnect, and retry. 1762 (Hard disk configuration error) 1. Hard disk drive. 2. Hard disk cables. 3. Run the Configuration/Setup Utility program. 4. Hard disk adapter. 5. SCSI backplane. 6. System board. 178X (Fixed disk error) 1. Hard disk cables. 2. Run diagnostics. 3. Hard disk adapter. 4. Hard disk drive. 5. System board. 1800 (No more hardware interrupt available for PCI adapter) 1. Run the Configuration/Setup Utility program. 2. Failing adapter. 3. System board. 80 xSeries 346 Types 8840 and 1880: Hardware Maintenance Manual and Troubleshooting Guide