IBM 8840 Hardware Maintenance Manual - Page 75
approximately
UPC - 000435863799
View all IBM 8840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
5. Attention: Be careful when handling the microprocessor and heat sink. If the thermal grease between the microprocessor and heat sink will be reused, do not contaminate it. If replacement thermal grease is provided with the replacement part, be sure to remove all traces of existing thermal grease from the remaining part before applying the new thermal grease. See "Thermal grease" on page 66 for instructions for removing and applying thermal grease. Rotate the heat-sink lever to the open position and carefully remove the heat sink. 6. Rotate the locking lever on the microprocessor socket from its closed and locked position until it stops or clicks in the fully open position (approximately 135° angle). Lever closed Lever closed Lever fully open Lever fully open 7. Attention: Do not use excessive force when removing the microprocessor form the socket. Remove the microprocessor. Chapter 5. Field replaceable units 65