IBM 8840 Hardware Maintenance Manual - Page 89
Configuration/Setup
UPC - 000435863799
View all IBM 8840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Note: See "System" on page 108 to determine which components a field service technician should replace. Error code/symptom FRU/action 262 (DRAM parity configuration error) 1. Run the Configuration/Setup Utility program. 2. Battery. 3. System board. 289 (DIMM disabled by POST or user) 1. Run the Configuration/Setup Utility program, if the DIMM was disabled by the user. 2. Disabled DIMM, if not disabled by user. 301 (Keyboard or keyboard controller error) 1. Keyboard 2. System board 303 (Keyboard controller error) System board 602 (Invalid diskette boot record) 1. Diskette 2. Diskette drive 3. Cable 4. System board 604 (Diskette drive error) 1. Run the Configuration/Setup Utility program and diagnostics. 2. Diskette drive. 3. Drive cable. 4. System board. 605 (Unlock failure) 1. Diskette drive 2. Drive cable 3. System board 662 (Diskette drive configuration error) 1. Run the Configuration/Setup Utility program and diagnostics. 2. Diskette drive. 3. Drive cable. 4. System board. 762 (Coprocessor configuration error) 1. Run the Configuration/Setup Utility program. 2. Battery. 3. Microprocessor. 962 (Parallel port error) 1. Disconnect the external cable on the parallel port. 2. Run the Configuration/Setup Utility program. 3. System board. 11XX (System board serial port 1 or 2 error) 1. Disconnect the external cable on the serial port. 2. Run the Configuration/Setup Utility program. 3. System board. 1301 (I2C cable to front panel not found) 1. Cable 2. Front panel 3. Power switch assembly 4. System board 1302 (I2C cable from system board to power on and reset switches not found) 1. Cable 2. Power switch assembly 3. System board Chapter 6. Symptom-to-FRU index 79