Icom ID-1 Instruction Manual - Page 91
Scan start/stop
View all Icom ID-1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
SCAN OPERATION 11 Scan start/stop D Preparation Set the scan resume condition (p. 89); program the scan edges (pgs. 85-87); program 2 or more memory channels (pgs. 74-76); set skip settings (p. 88), if desired. D Scanning from the application qSelect VFO mode for programmed scan; or memory mode for memory/mode select scan with [V/M]. • Select a memory channel which the desired operating mode is programmed. w Click [SCAN]. Click e Select the desired scan type. • After the selection, the selected scan starts. Selectable when VFO has been selected. Selectable when memory mode has been selected. *The above list indication is for instruction description only. In the actual application clearly shows the selectable items only. r To cancel the scan, click [SCAN] again then select "OFF." D Scanning with the RC-24 qSelect VFO when programmed scan; or select memory mode when memory/select mode scan with [V/M]. 11 • Select a memory channel which the desired operating mode is programmed. wPush [SCAN•8] momentarily to start programmed or mem- ory scan; push [SCAN•8] for 0.5 sec. to start select mode scan. • Decimal point, ".", blinks during programmed scan; "M" indica- tor blinks during memory/select mode scan. [SCAN•8] e To cancel the scan, push [SCAN•8] momentarily. 84