Texas Instruments TI-84 PLUS SILV Guidebook - Page 192

The top line displays list names. L1 through L6 are stored in columns 1 through 6 after a memory reset. The number of the current column is displayed in the top-right corner. The bottom line is the entry line. All data entry occurs on this line. The characteristics of this line change according to the current context. The center area displays up to seven elements of up to three lists; it abbreviates values when necessary. The entry line displays the full value of the current element. Using the Stat List Editor Entering a List Name in the Stat List Editor To enter a list name in the stat list editor, follow these steps. 1. Display the Name= prompt in the entry line in either of two ways. • Move the cursor onto the list name in the column where you want to insert a list, and then press y 6. An unnamed column is displayed and the remaining lists shift right one column. • Press } until the cursor is on the top line, and then press ~ until you reach the unnamed column. Note: If list names are stored to all 20 columns, you must remove a list name to make room for an unnamed column. The Name= prompt is displayed and alpha-lock is on. 2. Enter a valid list name in any of four ways. • Select a name from the LIST NAMES menu (Chapter 11). • Enter L1, L2, L3, L4, L5, or L6 from the keyboard. • Enter an existing user-created list name directly from the keyboard. • Enter a new user-created list name. 3. Press Í or † to store the list name and its elements, if any, in the current column of the stat list editor. Chapter 12: Statistics 185