Xerox M118i System Administration Guide - Page 60
EtherTalk Environments, EtherTalk Installation, Installation Procedure, Network Communication Setup
UPC - 095205219265
View all Xerox M118i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
5 EtherTalk EtherTalk Environments System configuration As the machine supports EtherTalk protocol, you can print from Macintosh. NOTE: You will need the optional PostScript Kit to use EtherTalk for printing. Target computers The machine supports a Macintosh or Power Macintosh with the following OS: • Mac OS 7.5 or later, 8.x, 9.x, or Mac OS X 10.2. EtherTalk Installation This section describes the installation procedure for using the machine in an EtherTalk Environment. Installation Procedure There are three stages required to install the machine on an EtherTalk network. Network Communication Setup This requires the machine to be set up for EtherTalk. Workstation Setup Install the print driver (Adobe PS) for Macintosh. Test Print A test print should be submitted to make sure that the machine has been installed and configured correctly. Network Communication Setup This procedure is used to set up the network communication parameters of the machine. At the machine, perform these steps. NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP network. NOTE: CentreWare Internet Services can also be used to configure the machine. Refer to CentreWare Internet Services chapter on page 91. Initially, boot the EtherTalk port. 1. Connect the machine to the network. 60 Xerox CopyCentre/WorkCentre 118 System Administration Guide