Xerox M118i System Administration Guide - Page 78
Parallel Port Environment, Parallel Port Installation, Installation Procedure
UPC - 095205219265
View all Xerox M118i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
8 Parallel Port Parallel Port Environment System configuration The machine can be connected directly to the parallel port of a host workstation. A document file can be sent from the host workstation via the parallel port to the machine for printing. Other workstations can be connected via a network to the host workstation. Each workstation has a queue that can hold a number of files. The document file is sent from the queue in the workstation to the queue in the host workstation, and then onto the queue in the machine to be printed. Target computers The following computers support printing through the parallel port. • Windows 95/Windows 98/Windows Me • Windows NT 4.0/Windows 2000/Windows XP/Windows Server 2003 Parallel Port Installation Follow these procedures to install and use the machine on the parallel port. Installation Procedure There are three stages required to install the machine on a parallel port. Parallel Port Communication Setup This requires the machine to be set up for parallel port printing. Workstation Setup This requires the workstation to be configured to print to the machine. Test Print A print job should be submitted to make sure that the machine has been installed and configured correctly. Parallel Port Communication Setup Connect the machine and the computer with an IEEE1284 Parallel Port Cable. 1. Insert the interface cable connector into the parallel interface connector of the machine and secure it using the wire clips on both sides. 2. Connect the other end of the interface cable connector to the computer. 3. Switch on the computer. 78 Xerox CopyCentre/WorkCentre 118 System Administration Guide