Cisco 6504-E User Guide - Page 157

Chapter 5 Physical Object Dialog Boxes C6576M Ethernet Interface Dialog Box • Delay Minimum-Time difference (in seconds) between a router power up and the time it can start preempting the currently active router. This value is only applicable when preemption is enabled. • Priority-Priority value that prioritizes a potential hot standby router. The range is 1 to 255, where 1 indicates the lowest priority and 255 indicates the highest priority. The default priority value is 100. The router in the HSRP group with the highest priority value becomes the active router. • Hello Interval-Hello interval in milliseconds. If this value is not configured, it can be learned from the active router. • Hold Interval-Hold interval in milliseconds. If this value is not configured, it can be learned from the active router. • Configure button-Enable HSRP for IP on an interface. This action deploys an HSRP group on the interface. The HSRP group may optionally be assigned a primary IP address. If no address is explicitly assigned, the device attempts to discover the virtual IP address from the active server using Hello messages. Figure 5-20 shows the subdialog box displayed when the Add/Remove button is pressed. Figure 5-20 HSRP Group Configure Subdialog Box Cisco 6500/7600 Series Manager User Guide 5-43