Cisco 6504-E User Guide - Page 201

Chapter 5 Physical Object Dialog Boxes C6576M ATM T3 Interface Dialog Box Routing Protocol Tab Figure 5-44 shows the Routing Protocol tab of the C6576M ATM T3 Interface dialog box. Figure 5-44 Routing Protocol Tab of the C6576M ATM T3 Interface Dialog Box OSPF Area The OSPF area contains the following information: • OSPF Network Type-OSPF network type. ATM is a point-to-point service; by default it is considered to be nonbroadcast by the OSPF routing process. An ATM interface can be configured as a broadcast interface. The OSPF network type also can be dependent on the ATM network configuration, whether or not the network is partially meshed or fully meshed. • Area ID-The predefined ID uniquely identifying the area to which the interface connects. It can be specified as either a decimal value or as an IP address. Value is 0.0.0.0 if interface is a layer 2 (no IP address assigned) interface. This attribute is read-only. • Authentication Key-Password to be used by neighboring OSPF routers on a network segment that is using OSPF simple password authentication. It is ignored if OSPF Authentication Type is not "simple". This attribute is read-only. • Hello Interval-Length of time between the hello packets sent on an OSPF interface. Must be consistent between all routers on an attached network. This attribute is read-only. Cisco 6500/7600 Series Manager User Guide 5-87