Cisco 6504-E User Guide - Page 212
Routing Protocol Tab of the C6576M ATM E3 Interface Dialog Box
View all Cisco 6504-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 212 highlights
C6576M ATM E3 Interface Dialog Box Chapter 5 Physical Object Dialog Boxes Routing Protocol Tab Figure 5-50 shows the Routing Protocol tab of the C6576M ATM E3 Interface dialog box. Figure 5-50 Routing Protocol Tab of the C6576M ATM E3 Interface Dialog Box OSPF Area The OSPF area contains the following information: • OSPF Network Type-OSPF network type. ATM is a point-to-point service; by default it is considered to be nonbroadcast by the OSPF routing process. An ATM interface can, however, be configured as a broadcast interface. The OSPF network type can also be dependent on the ATM network configuration, whether the network is partially meshed or fully meshed. • Area ID-The predefined ID uniquely identifying the area to which the interface connects. It can be specified as either a decimal value or as an IP address. Value is 0.0.0.0 if interface is a layer 2 (no IP address assigned) interface. This attribute is read-only. • Authentication Key-Password to be used by neighboring OSPF routers on a network segment that is using OSPF simple password authentication. This password is ignored if OSPF Authentication Type is not "simple". This attribute is read-only. • Hello Interval-Length of time between the hello packets sent on an OSPF interface. Must be consistent among all routers on an attached network. This attribute is read-only. 5-98 Cisco 6500/7600 Series Manager User Guide