Cisco 6504-E User Guide - Page 39

Getting Started CH A P T E R 3 This chapter describes the typical tasks to be completed when first using the Cisco 6500/7600 Series Manager, and consists of the following sections: • Preparing to Use the C65/76M Software, page 3-1 • Using Cisco EMF, page 3-2 • Deploying C65/76M Objects, page 3-7 • Launching Object Management Dialogs, page 3-10 Preparing to Use the C65/76M Software The following table outlines the general steps involved in using the C65/76M software. Table 3-1 Using C65/76M Step 1 Step 2 Step 3 Step 4 Step 5 Steps Install and start Cisco EMF. Install the C65/76M software. Set up the Catalyst 6000 family switch or the Cisco 7600 series Internet Router. Start a Cisco EMF session. Deploy objects. Description Refer to the Cisco Element Management Framework Installation and Administration Guide for more information on how to install and start Cisco EMF. Refer to the Cisco 6500/7600 Manager Installation Guide for more information. You must configure the Catalyst 6000 family switch or Cisco 7600 series Internet Router before it can be properly managed by Cisco EMF. Refer to the "Hardware Configuration Requirements" section in the Cisco 6500/7600 Manager Installation Guide for more information. Starting a Cisco EMF user session provides access to all C65/76M functionality. Refer to the "Deploying C65/76M Objects" section of this chapter for more information. Cisco 6500/7600 Series Manager User Guide 3-1