Cisco 6504-E User Guide - Page 219

Chapter 5 Physical Object Dialog Boxes C6576M ATM SONET Interface Dialog Box General Area The General area contains the following information: • Link Up/Down Trap-Enables or disables linkUp and linkDown trap generation for the interface. • Bandwidth-Overwrites default bandwidth in kilobits per second. Note The Bandwidth attribute is an informational parameter used only to communicate the current bandwidth to the higher-level protocols (such as IGRP, EIGRP, and OSPF); you cannot adjust the actual bandwidth of an interface with this command. • Delay-Specifies the delay in tens of microseconds for an interface or network segment. Note The Delay attribute is an informational parameter used only to communicate the current bandwidth to the higher-level protocols (such as IGRP and EIGRP); you cannot adjust the actual delay of an interface with this command. • Input Queue Length-Input queue length in packets. • Output Queue Length-Output queue length in packets. Layer 2 Area The Layer 2 area contains the following information: • MAC Address-Displays the MAC address of the interface. • MTU-The size of the largest packet which can be sent or received on the interface, specified in octets. Layer 3 Area The Layer 3 area contains the following information: • IP Address-Displays the IP address of the Layer 3 interface. • Netmask-Subnet mask of the interface IP address. Enabled bits indicate the network addressing bits in the IP address. • Clear IP Address button - After receiving confirmation, will unset the IP address for this interface. Cisco 6500/7600 Series Manager User Guide 5-105