Cisco 6504-E User Guide - Page 412

C6576M QoS Dialog Box Chapter 6 Logical Object Dialog Boxes • Conform Action-Action to be taken when traffic conforms to QoS parameters. This attribute has one of the following values: - Drop-Drops packet - Transmit-Transmits packet - Set DSCP-Assigns DSCP value to packet before it is transmitted. - Set Precedence-Assigns IP Precedence value to packet before it is transmitted. - A value of none (0) indicates no conform action has been specified. • Set DSCP-Integer DSCP value assigned to packets of conforming ingress traffic before transmitting on egress interfaces. This value is only relevant and will only be set in the running configuration of the device if the Conform Action attribute is Set DSCP. • Set IP Precedence-IP Precedence integer value assigned to packets of conforming ingress traffic before transmitting on egress interfaces. This value is only relevant and will only be set in the running configuration of the device if Conform Action is Set Precedence. • Exceed Action-Action to be taken when traffic exceeds QoS parameters. This atttribute has one of the following values: - Drop-Drops packet. - Policed DSCP Transmit-Changes the DSCP as per the policed DSCP map before transmitting. - Transmit-Transmits packet. - A value of none (0) indicates an exceed action has not been specified. • Violate Action-Action to be taken when traffic violates QoS parameters. This atttribute has one of the following values: - Drop-Drops packet. - Policed DSCP Transmit-Changes the DSCP as per the policed DSCP map before transmitting. - Transmit-Transmits packet. - A value of none (0) indicates that a violate action has not been specified. Note The Violate Action feature is not supported in IOS 12.1(6)E and earlier. A PFC2 card is also required. • New Policer button-Launches a subdialog box, shown in Figure 6-97, to create an aggregrate policer on the managed device with the specified rate, burst, and max-burst values. 6-122 Cisco 6500/7600 Series Manager User Guide