Cisco 6504-E User Guide - Page 420

C6576M QoS Policy Map Dialog Box Chapter 6 Logical Object Dialog Boxes Figure 6-104 Policy Map Add Class Subdialog Box of C6576M QoS Policy Map Dialog Box The following is shown in this subdialog box. Class Name Area • Class Name Table-Lists the classes by the Class Map Name. • Class Map Name-Unique identifier of the policy map class on the device. • Type-Indicates whether the selected class map can be used on Ethernet interfaces or not. The C65/76M EMS will discover class maps that are not suitable for use with Ethernet interfaces, however you cannot add, remove, or configure these class maps. They are listed in the table only to indicate that the class map names are in use. This attribute has one of the following values: - ethernet-The class map can be used on Ethernet interfaces. - other-Indicates that a class map contains more than one match entry or it contains a match criteria that is unsupported on Ethernet interfaces. - empty-Indicates a class map with no match entries. An empty class map cannot be applied to an Ethernet interface, however you may modify it. Aggregate Policer • Aggregate Enabled- Indicates whether or not an explicit policer is defined for the policy map class. This enables QoS policing against Layer-3 switched traffic flows. • Named Aggregate-Unique string identifier of an aggregate policer on the device. This value is nil if an explicit aggregate policer is defined within this policy map class. This is supported in Native IOS only. • Rate-Maximum transmission rate, in bits per second, to enforce against policed traffic. This value is mandatory when defining an explicit policer. A value of 0 is returned on read if an explicit policer is not defined for the policy map class. 6-130 Cisco 6500/7600 Series Manager User Guide