D-Link DGS-3627G Product Manual - Page 278
IGMP Check Subscriber Source Network Settings
UPC - 790069293764
View all D-Link DGS-3627G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 278 highlights
xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch This window allows the configuration of IGMP for each IP interface configured on the Switch. IGMP can be configured as Version 1, 2 or 3 by toggling the Version field using the pull-down menu. The length of time between queries can be varied by entering a value between 1 and 31,744 seconds in the Query Interval field. The maximum length of time between the receipt of a query and the sending of an IGMP response report can be varied by entering a value in the Max Response Time field. The Robustness Variable field allows IGMP to be 'tuned' for sub-networks that are expected to lose many packets. A high value (max. 255) for the robustness variable will help compensate for 'lossy' sub-networks. A low value (min. 2) should be used for less 'lossy' sub-networks. The following fields can be set: Parameter Description Interface Name Displays the name of the IP interface that is to be configured for IGMP. This must be a previously configured IP interface. IP Address Displays the IP address corresponding to the IP interface name above. Version Enter the IGMP version (1, 2 or 3) that will be used to interpret IGMP queries on the interface. Query Interval (131744) Allows the entry of a value between 1 and 31744 seconds, with a default of 125 seconds. This specifies the length of time between sending IGMP queries. Max Response Time Sets the maximum amount of time allowed before sending an IGMP response report. A (1-25) value between 1 and 25 seconds can be entered, with a default of 10 seconds. Robustness Variable A tuning variable to allow for subnetworks that are expected to lose a large number of (1-255) packets. A value between 1 and 255 can be entered, with larger values being specified for subnetworks that are expected to lose larger numbers of packets. The default setting is 2. Last Member Query Interval (1-25) Specifies the maximum amount of time between group-specific query messages, including those sent in response to leave group messages. A value between 1 and 25. The default is 1 second. State This field can be toggled between Enabled and Disabled and enables or disables IGMP for the IP interface. The default is Disabled. Click Apply to implement changes made. IGMP Check Subscriber Source Network Settings This window allows users to configure IGMP check subscriber source network settings. When Check Subscriber Source Network is enabled on an interface, every IGMP report/leave message received by the interface will be checked to see whether its source IP is in the same network as the interface. If the check is disabled, an IGMP report/leave message with any source IP can be processed by IGMP protocol. To view this Table, click L3 Features > IP Multicast Routing Protocol > IGMP Check Subscriber Source Network Settings, as shown below: Figure 4- 118. IGMP Check Subscriber Source Network Settings window 262