D-Link DGS-3627G Product Manual - Page 352

xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch Figure 6- 35. CPU Interface Filtering Rule Configuration window (IP) Configure the following Access Rule Configuration settings for IP: Parameter Description Profile ID This is the identifier number for this profile set. Mode Select Permit to specify that the packets that match the access profile are forwarded by the Switch, according to any additional rule added (see below). Select Deny to specify that packets that do not match the access profile are not forwarded by the Switch and will be filtered. Access ID Type in a unique identifier number for this access and priority. This value can be set from 1 to 100. Type VLAN Name Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask or IPv6. Ethernet instructs the Switch to examine the layer 2 part of each packet header. IP instructs the Switch to examine the IP address in each frame's header. Packet Content Mask instructs the Switch to examine the packet header. IPv6 instructs the Switch to examine the IPv6 part of the packet header. Allows the entry of a name for a previously configured VLAN. Source IP Source IP Address - Enter an IP Address mask for the source IP address. Destination IP Destination IP Address- Enter an IP Address mask for the destination IP address. DSCP (0-63) This field allows the user to enter a DSCP value in the space provided, which will instruct the Switch to examine the DiffServ Code part of each packet header and use this as the, or part of the criterion for forwarding. The user may choose a value between 0 and 63. Port The CPU Access Rule may be configured on a per-port basis by entering the port number of the Switch. Time Range Tick the check box and enter the name of the Time Range settings that has been previously configured in the Time Range Settings window. This will set specific times when this CPU 336