D-Link DGS-3627G Product Manual - Page 423

xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch Methods VID List State None - Specifies that multiple authentication is not enabled. Any - Specifies that a client will gain access if it passes any of the authentication methods (802.1X, MAC, or JWAC). 802.1X+IMPB - Specifies that 802.1X+IMPB can be enabled on a port at the same time. 802.1X will be verified first, and then IMPB will be verified. Both authentication methods need to be passed. If either authentication method fails, the client will be denied access. IMPB+JWAC - Specifies that JWAC and IMPB can be enabled on a port at the same time. JWAC will be verified first, and then IMPB will be verified. Both authentication methods need to be passed. If either authentication method fails, the client will be denied access. Enter a list of VLAN IDs. Use the pull-down menu to enable or disable this function. Click Apply to implement changes made. Authentication Guest VLAN Settings This window is used to display and configure the Authentication Guest VLAN settings on the Switch. To view this window, click Security > Compound Authentication > Compound Authentication Guest VLAN Settings, as shown below: Figure 7- 76. Authentication Guest VLAN Table window To configure a new entry click the Add button, to reveal the following window: Figure 7- 77. Authentication Guest VLAN Settings - Add window The following parameters may be set: Parameter Description VID / VLAN Name Select either VID or VLAN Name and enter the appropriate information about a previously configured VLAN. Port List (e.g.:1,6-9) Enter the port or list of ports you wish to configure. Check the Select All Ports check box to select all ports. Action Select the action you wish to apply to the Guest VLAN. Select Add to add a port to the Guest VLAN portlist or Delete to remove ports from the Guest VLAN portlist. Click Apply to implement changes made. 407