D-Link DGS-3627G Product Manual - Page 297

xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch setting is Disabled. If no number is supplied, the default value of three times is used. Allowas In Value (1- Enter an Allowas In Value between 1 and 10. 10) Default Originate State Enable or disable the default originate function. By default, this setting is Disabled. Route Map Name Enter a Route Map Name of a maximum of 16 characters. EBGP Multihop (1255) Enter the TTL of the BGP packet sent to the neighbor. For an EBGP neighbor the default setting is 1. This means only direct connected neighbors are allowed. Weight (0-65535) Enter a value for weight. The valid range is from 0 to 65535. If this is not specified, the routes learned through another BGP peer will have a default weight of 0. Routes sourced by the local router have a weight of 3768. It cannot be changed. Update Source Enter an interface to be used by BGP sessions for TCP connection. By default, this parameter is not set. BGP Neighbor Timer Settings IP Address Enter the IP address of the neighbor to be configured. Peer Group Name Enter the peer group to be configured. Advertisement Interval (0-600) Enter the interval at which the BGP process sends update messages to its peer. The valid value is from 0 to 600. If this value is set to zero, the update or withdrawn message will be sent immediately. The default value for IBGP peers is 5 seconds and for EBGP peers it is 30 seconds. When the default check box is ticked, the neighbor specific advertisement interval setting will be returned to the default setting. Keep Alive (0-65535) Enter the interval at which a keepalive message is sent to its peers. If the two routers, that build a BGP connection, have different keepalive timers, the smaller keepalive timer will be unset. The valid value is from 0 to 65535. If the keepalive is set to zero, then the keepalive message will not be sent out. By default, the timer is not specified. This neighbor specific setting will follow the global setting. Hold Time (0-65535) The system will declare a peer as dead if not receiving a keepalive message until the hold time. If two routers, that built a BGP connection, have different hold times, the smaller hold time will be used. The valid value is from 0 to 65535. If the holdtime is zero, then the holdtime will never expire. It is recommended that the holdtime value is three times that of the keepalive timer. By default, the timer is not specified. This neighbor specific setting will follow the global setting. AS Origination Interval (1-600) Enter the minimum interval between the sending AS origination routing updates. The valid value is from 1 to 600. The default setting is 15 seconds. Connect Retry Interval (1-65535) Enter the minimum interval BGP sends TCP connect requests to the peer after a TCP connection fail happens. The valid value is from 1 to 65535. The default setting is 120 seconds. Click Apply to implement changes made. 281