D-Link DGS-3627G Product Manual - Page 350

xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch Figure 6- 32. CPU Interface Filtering Rule Configuration window (Ethernet) To set the CPU Access Rule for Ethernet, adjust the following parameters and click Apply. Parameters Description Profile ID This is the identifier number for this profile set. Mode Select Permit to specify that the packets that match the access profile are forwarded by the Switch, according to any additional rule added (see below). Select Deny to specify that packets that do not match the access profile are not forwarded by the Switch and will be filtered. Access ID Type in a unique identifier number for this access and priority. This value can be set from 1 to 100. Type VLAN Name Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask or IPv6. Ethernet instructs the Switch to examine the layer 2 part of each packet header. IP instructs the Switch to examine the IP address in each frame's header. Packet Content Mask instructs the Switch to examine the packet header. IPv6 instructs the Switch to examine the IPv6 part of the packet header. Allows the entry of a name for a previously configured VLAN. Source MAC Source MAC Address - Enter a MAC Address for the source MAC address. Destination MAC Destination MAC Address - Enter a MAC Address mask for the destination MAC address. Ethernet Type Specifies that the access profile will apply only to packets with this hexadecimal 802.1Q Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet type value may be set in the form: hex 0x0-0xffff, which means the user may choose any combination of letters and numbers ranging from a-f and from 0-9. Port The CPU Access Rule may be configured on a per-port basis by entering the port number of the Switch. 334