HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 119

Switch Memory and Configuration Using the Menu and Web Browser Interfaces To Implement Configuration Changes To save and implement the changes for all parameters in this screen, press the [Enter] key, then press [S] (for Save). To cancel all changes, press the [Enter] key, then press [C] (for Cancel) Note Figure 6-4. Example of Pending Configuration Changes You Can Save or Cancel If you reconfigure a parameter in the CLI and then go to the menu interface without executing a write memory command, those changes are stored only in the running configuration (even if you execute a Save operation in the menu interface). If you then execute a switch boot command in the menu interface, the switch discards the configuration changes made while using the CLI. To ensure that changes made while using the CLI are saved, execute write memory in the CLI before rebooting the switch. Rebooting from the Menu Interface ■ Terminates the current session and performs a reset of the operating system ■ Activates any configuration changes that require a reboot ■ Resets statistical counters to zero (Note that statistical counters can be reset to zero without rebooting the switch. See "To Display the Port Counter Summary Report" on page 13.) To Reboot the switch, use the Reboot Switch option in the Main Menu. (Note that the Reboot Switch option is not available if you log on in Operator mode; that is, if you enter an Operator password instead of a manager password at the password prompt.) 6-11