HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 274
LACP Notes and Restrictions, 1X Port-Based Access Control Con d on a Port.
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 274 highlights
Port Trunking Trunk Group Operation Using LACP Status Name LACP Status Meaning Success: LACP is enabled on the port, detects and synchronizes with a device on the other end of the link, and can move traffic across the link. Failure: LACP is enabled on a port and detects a device on the other end of the link, but is not able to synchronize with this device, and therefore not able to send LACP packets across the link. This can be caused, for example, by an intervening device on the link (such as a hub), a bad hardware connection, or if the LACP operation on the opposite device does not comply with the IEEE 802.3ad standard. LACP Notes and Restrictions 802.1X (Port-Based Access Control) Configured on a Port. To maintain security, LACP is not allowed on ports configured for 802.1X authenticator operation. If you configure port security on a port on which LACP (active or passive) is configured, the switch removes the LACP configuration, displays a notice that LACP is disabled on the port(s), and enables 802.1X on that port. ProCurve(config)# aaa port-access authenticator b1 LACP has been disabled on 802.1x port(s). ProCurve(config)# The switch will not allow you to configure LACP on a port on which port access (802.1X) is enabled. For example: ProCurve(config)# int b1 lacp passive Error configuring port < port-number >: LACP and 802.1x cannot be run together. ProCurve(config)# To restore LACP to the port, you must first remove the port's 802.1X configuration and then re-enable LACP active or passive on the port. Port Security Configured on a Port. To maintain security, LACP is not allowed on ports configured for port security. If you configure port security on a port on which LACP (active or passive) is configured, the switch removes the LACP configuration, displays a notice that LACP is disabled on the port(s), and enables port security on that port. For example: ProCurve(config)# port-security a17 learn-mode static address-limit 2 LACP has been disabled on secured port(s). ProCurve(config)# The switch will not allow you to configure LACP on a port on which port security is enabled. For example: 11-22