HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 160

Note Interface Access and System Information Interface Access: Console/Serial Link, Web, and Inbound Telnet If you change the Baud Rate or Flow Control settings for the switch, you should make the corresponding changes in your console access device. Otherwise, you may lose connectivity between the switch and your terminal emulator due to differences between the terminal and switch settings for these two parameters. All console parameter changes except events and inactivity-timer require that you save the configuration with write memory and then execute boot before the new console configuration will take effect. For example, to use one command to configure the switch with the following: ■ VT100 operation ■ 19,200 baud ■ No flow control ■ 10-minute inactivity time ■ Critical log events you would use the following command sequence: The switch implements the Event Log change immediately. The switch implements the other console changes after executing write memory and reload. Figure 7-4. Example of Executing the Console Command with Multiple Parameters 7-9