HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 129

Switch Memory and Configuration Using Primary and Secondary Flash Image Options Table 6-2. Comparing the Boot and Reload Commands Actions Included In Included In Reload Note Boot? Save all configuration changes since the last boot or reload Optional, with prompt Optional with reload , when prompt displays. Not saved with reload at/after commands; No prompt is displayed. Config changes saved to the startup-config file if "y" is selected (reload command). Perform all system Yes No self-tests The reload command provides a faster system reboot. Choice of primary or Yes secondary flash image No-Uses the current flash image. Perform a scheduled No Yes reboot Use the reload command with after/at parameters (see page 6-24 for details). Setting the Default Flash You can specify the default flash to boot from on the next boot by entering the boot set-default flash command. Syntax: boot set-default flash [primary |secondary] Upon booting, set the default flash for the next boot to primary or secondary. ProCurve(config)# boot set-default flash secondary ProCurve(config)# show flash Image Size(Bytes) Date Version ----- Primary Image : 7173079 07/27/09 Z.14.04 Secondary Image : 7173079 07/27/09 Z.14.04 Boot Rom Version: Z.14.03 Default Boot : Secondary ProCurve(config)# boot This management module will now reboot from secondary and will become the standby module! You will need to use the other management module's console interface. Do you want to continue [y/n]? Figure 6-13.Example of boot set-default Command with Default Flash Set to Secondary (with a Redundant Management Module Present) 6-21