HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 223

Port Status and Configuration Viewing Port Status and Configuring Port Parameters CLI: Viewing Port Status and Configuring Port Parameters From the CLI, you can configure and view all port parameter settings and view all port status indicators. Port Status and Configuration Commands show interfaces brief show interfaces config show interfaces custom show interfaces port-utilization show tech transceivers interface disable/enable speed-duplex flow-control broadcast-limit auto-mdix page 10-9 page 10-9 page 10-10 page 10-13 page 10-14 page 10-15 page 10-15 page 10-15 page 10-17 page 10-18 page 10-19 Viewing Port Status and Configuration Use the following commands to display port status and configuration data. Syntax: show interfaces [ brief | config | < port-list >] brief: Lists the current operating status for all ports on the switch. config: Lists a subset of configuration data for all ports on the switch; that is, for each port, the display shows whether the port is enabled, the operating mode, and whether it is configured for flow control. < port-list >: Shows a summary of network traffic handled by the specified ports. An example of the show interfaces brief command is shown below. 10-8